When you see water coming out from the water heater release valve there are two most likely causes.
Water heater pressure relief valve pipe dripping.
So this release of its pressure causes your hot water tank overflow pipe dripping towards the floor where the hot water heater is placed.
If a pressure relief valve for a boiler is accidentally installed on a water heater it will leak like crazy from the start.
These valves may look identical but they re set to go off at 30 psi.
In the first case the valve will drain water out of the discharge pipe as explained above.
If your valve is dripping that may be a.
The t and p valve which is located on the top or side of the tank opens and releases water or steam when the temperature or pressure exceed preset limits.
This temperature pressure relief valve is attached to the discharge pipe.
It is critically important that the temperature pressure relief valve must work properly with your hot water heater overflow pipe leaking.
Your water heater s relief valve can start leaking for one of two reasons.
Pressure relief valves sometime develop a drip when opened for the first time in years.
Try opening and closing it a few times to see if it will seat itself.
If hot water heater overflow or starts leaking the damaged temperature pressure relief valve is usually the reason.
If a pressure relief valve for a boiler is accidentally installed on a water heater it will leak like crazy from the start.
These valves may look identical but they re set to go off at 30 psi.
But if the termination of the piping is not readily visible such as if it is located under the house the water will continue to drain until the homeowner gets an amazing electric or gas bill and goes searching for the reason.
It s designed to release the pressure when there is too much of a load built up inside the water heater.
One of such systems is the hot water heater overflow leaking.
There s a problem with the valve such as a faulty seal and the water is unintentionally leaking.
The relief valve is working the way it s intended and water drained to reduce the pressure inside the tank.
Release the pressure in the pipes using the lever on the pressure release valve.
If the water heater thermostat fails to turn off at its temperature setting and continues to heat the water indefinitely the tpr valve will open and let the overheated water out.
Either the valve was triggered to open because of excessive temperature or pressure or the valve itself is faulty.